Successive Ionic Layer Adsorption and Reaction‐Deposited Transparent Cu–Zn–S Nanocomposites as Hole Transport Materials in CdTe Photovoltaics
Abstract
Evolving material science and device architectures continue to drive improvements in photovoltaic solar cell performance. Herein, the synthesis and application of p‐type transparent copper–zinc–sulfide (Cu–Zn–S) nanocomposite thin films for application as a semi‐transparent back buffer layer for cadmium telluride (CdTe) photovoltaics is reported. Earth‐abundant and low‐toxicity Cu–Zn–S films are prepared at room temperature using successive ionic layer adsorption and reaction (SILAR). Transparency in the range of 500–800 nm, low resistivity, and composition‐controlled bandgap energy offer a compelling material system for high performance as an electron reflector enabling bifacial cell design. Implementing the Cu–Zn–S hole transport material (HTM) at the CdTe back contact, without intentional introduction of Cu doping, converts simulated AM1.5 sunlight to electricity at an efficiency up to 13.2%, with an average device performance of 13.0%. Intentional Cu doping yields a best efficiency of 14.3% with open‐circuit voltage (VOC) of 848 mV and fill factor (FF) of 77.3% (average 14.1%). Our study shows the clear promise of this material for highly efficient and semi‐transparent back contact to CdTe solar cells.
Document Details
- Document Type
- Pub Defense Publication
- Publication Date
- Sep 07, 2020
- Source ID
- 10.1002/ente.202000429
Entities
People
- Adam B. Phillips
- Ebin Bastola
- Fadhil K. Alfadhili
- Kamala Khanal Subedi
- Michael J. Heben
- Randy J Ellingson
Organizations
- Air Force Research Laboratory