Cascade type-I quantum well diode lasers emitting 960 mW near 3 μm
Abstract
The cascade pumping scheme reduced the threshold current density of high power type-I quantum well GaSb-based λ ∼ 3 μm diode lasers down to ∼100 A/cm2 at room temperature. Laser heterostructures had single GaInAsSb quantum well gain stages connected in series by means of GaSb/AlSb/InAs tunnel junctions followed by InAs/AlSb electron injectors. Devices with densely stacked two and three gain stages and 100-μm-wide aperture demonstrated peak power conversion efficiency of 16% and continuous wave output power of 960 mW. Corresponding narrow ridge lasers demonstrated above 100 mW of output power. The experiment showed that the bandwidth of the gain and its rate of increase with current depended strongly on the thickness of AlSb layer separating electron injectors from quantum wells. The possible impact of electron injector interfaces and ionized impurities on the carrier scattering and recombination in the active quantum well is discussed.
Document Details
- Document Type
- Pub Defense Publication
- Publication Date
- Oct 20, 2014
- Source ID
- 10.1063/1.4900506
Entities
People
- G. Kipshidze
- Gregory Belenky
- L. Shterengas
- Richard L. Tober
- Rui Liang
- Sherrie S. Bowman
- Takashi Hosoda
Organizations
- Army Research Office
- Stony Brook University
- United States Army Research Laboratory